CHEMISTRY GLOSSARY

nominal    →   nominalno

Nominal is used to describe a process where 100 % accuracy is not guaranteed. For example, sand filtres are usually sold to filtre to a nominal 10 μm, which means that they will filtre most particles of 10 μm and larger, but not all. A filtre which is guaranteed to filtre all particles of 10 μm would be termed absolute rather than nominal.

relative mistake    →   relativna pogreška

Relative mistake is a relation between absolute mistake (O-μ) and the real value (μ). It is expressed in percentage (%).

seawater    →   more

Seawater is a complex mixture of 96.5 % water, 3.5 % salts, and smaller amounts of other substances, including dissolved inorganic and organic materials, particulates, and a few atmospheric gases. The world's oceans cover nearly 71 % (361 840 000 km²) of the Earth's surface (510 100 000 km²), with an average depth of 3 682.2 m.

The density of seawater is higher than that of fresh water because of its higher salinity. Seawater's freezing point is lower than that of pure water and its boiling point is higher. The average salinity of the ocean is 35 ‰, which means that for every kilograms of water, there are 35 g of salt. The relative abundance of the major salts in seawater are constant regardless of the ocean. Only six elements and compounds comprise about 99 % of sea salts: chlorine (Cl^-), sodium (Na⁺), sulfur (SO₄^2-), magnesium (Mg²⁺), calcium (Ca²⁺), and potassium (K⁺).

vacuum    →   vakuum

Vacuum (absolute vacuum) is a volume which contains no matter.

significant figures    →   značajne znamenke

Measurements are not infinitely accurate: we must estimate measurement uncertainty. The number of significant figures is all of the certain digits plus the first uncertain digit.

Rules for significant figures:

1. Disregard all initial zeros.
2. Disregard all final zeros unless they follow a decimal point.
3. All remaining digits including zeros between nonzero digits are significant.

In addition and subtraction, the number of significant figures in the answer depends on the original number in the calculation that has the fewest digits to the right of the decimal point.

In multiplication and division, the number of significant figures in a calculated result is determined by the original measurement that has the fewest number of significant digits.

In a logarithm of a number, keep as many digits to the right of the decimal point as there are significant figures in the original number.

In an antilogarithm of a number, keep as many digits as there are digits to the right of the decimal point in the original number.

standard deviation    →   standardna devijacija

Standard deviation (σ) is a measure of the dispersion of a set of data from its mean. Standard deviation is a statistical term that measures the amount of variability or dispersion around an average

Suppose there are many measurements of a quantity presumed to be similar, like the size of peas in a pod. If the number of readings for each size were plotted, a bell-shaped curve would probably result, with a few small and large peas and most clustered around the average size. Around two-thirds of all measurements fall in the range spanned by the standard deviation, a measure of the spread.

Heyrovsky-Ilkovic equation    →   Heyrovsky-Ilkovičeva jednadžba

The Heyrovsky-Ilkovic equation describes the entire current-potential curve (polarographic wave) of a reversible redox system in polarography

where R is the gas constant, T is the absolute temperature, F is the Faraday constant, n denotes the number of electrons taking part in the electrode reaction. E_1/2 is a unique potential (for a given reaction and supporting electrolyte) termed the half-wave potential.

In order to obtain E_1/2 from the above equation, we plot a graph of ln[(i_d-i)/i] against E. The intercept on the x-axis gives then an accurate value of E_1/2. The slope of the obtained straight line is equal to nF/RT from which n is determined.