CHEMISTRY GLOSSARY

solubility product constant    →   konstanta produkta topljivosti

Solubility product constant (K_sp) (or the solubility product) is the product of the molar concentrations of the constituent ions, each raised to the power of its stoichiometric coefficient in the equilibrium equation. For instance, if a compound A_aB_b is in equilibrium with its solution

the solubility product is given by

standard hydrogen electrode    →   standardna vodikova elektroda

Standard hydrogen electrode is a system in which hydrogen ion and gaseous hydrogen are present in their standard states. The convention is to designate the cell so that the standard hydrogen electrode is written first.

The electrode is used as a reference (of zero) for the values of other standard electrode potentials.

stoichiometric coefficient    →   stehiometrijski koeficijent

Stoichiometric coefficient (ν) is the number appearing before the symbol for each compound in the equation for a chemical reaction. By convention, it is negative for reactants and positive for products.

Stoichiometric coefficients describe the stoichiometry of the chemical reaction.

In this equation, a, b, c and d are called as Stoichiometric coefficients of the A, B, C and D respectively.

stoichiometry    →   stehiometrija

Stoichiometry is the relative proportions elements from compounds or in which substances react. Every chemical reaction has its characteristic proportions. For example, when methane unites with oxygen in complete combustion, 1 mol of methane requires 2 mol of oxygen.

At the same time, 1 mol of carbon dioxide and 2 mol of water are formed as reaction products.

Alternatively, 16 g of methane and 64 g of oxygen produce 44 g of carbon dioxide and 36 g of water.

The stoichiometric relationship between the products and reactants can be used to in calculations.

supercritical carbon dioxide    →   superkritični ugljikov dioksid

Supercritical carbon dioxide (scCO₂) is a powerful, cheap, non-toxic and environmental friendly solvent. When used at a supercritical state (over 74 bar and 31 °C), it achieves similar solvating power as its organic competitors, such as hydrocarbons and chlorinated solvents. Supercritical carbon dioxide is one of few solvents that can be unrestrictedly used for food processing.

Tafel plot    →   Tafelov dijagram

Tafel plot is the graph of the logarithm of the current density j against the overpotential η in electrochemistry in the high overpotential limit. An electrode when polarised frequently yields a current potential relationship over a region which can be approximated by:

where η is change in open circuit potential, i is the current density, B and i₀ is constants. B is known as the Tafel Slope. If this behaviour is observed a plot of the semilogarithmic components is known as the Tafel line and the diagram is called the Tafel diagram.

thermal resistance    →   toplinski otpor

Heat always flows from a higher to a lower temperature level. The driving force for the heat flux lies in the temperature difference ΔT between two temperature levels. Analogous to Ohm’s law, the following holds:

where H = dQ/dt is heat flux, measured in watts, ΔT is temperature difference across the thermal resistance, measured in kelvin, and R_th is thermal resistance, measured in K/W.

For example, suppose there were two houses with walls of equal thickness; one is made of glass and the other of asbestos. On a cold day, heat would pass through the glass house much faster. The thermal restistance of asbestos is then higher than of glass.

If the thermal Ohm’s law is divided by the heat capacity C, Newton’s law of cooling is obtained:

where dT/dt is rate of cooling or heating, measured in K s^-1, and C is heat capacity, measured in J K^-1.

U-tube manometer    →   U-manometar

U-tube manometer contains water or mercury in a U-shaped tube, and is usually used to measure gas pressure. One end of the U tube is exposed to the unknown pressure field (P) and the other end is connected to a reference pressure source (usually atmospheric pressure) (P_ref), shown in the schematic below.

If fluid C is the atmosphere, fluid B is the liquid in the U tube (e.g. water or mercury), and fluid A is a gas, then we can assume that ρB >> ρA, ρC. The pressure contributed by the weight of gas within the U tube can therefore be neglected. The gage pressure of the gas can be approximated by,

Winkler’s method    →   Winklerova metoda

Winkler’s method was once a common method used to determine the dissolved oxygen concentration by titration. Now rarely used due to the accuracy and low price of oxygen meters.

The water sample is first treated with excess manganese(II) sulfate solution and then with an alkaline solution of potassium iodide. The Mn(OH)₂ initially formed reacts with the dissolved oxygen. The amount of MnO(OH)₂ formed is determined by reaction with iodide ion in acidic solution. The iodine formed may be titrated against standard thiosulfate solution, using starch as an indicator.

X-ray diffraction    →   rendgenska difrakcija

The regular array of atoms in a crystal is a three-dimensional diffraction grating for short-wavelength waves such as X-rays. The atoms are arranged in planes with interplanar spacing d. Diffraction maxima occur in the incident direction of the wave, measured from the surface of a plane of atoms, and the wavelength λ of the radiation satisfy Braggs’s law: