CHEMISTRY GLOSSARY

standard atmosphere    →   standardna atmosfera

See Atmosphere

atmosphere    →   atmosfera

1. Atmosphere is the column of air which is extending several hundred kilometers above the surface the Earth's surface. The density of this air decreases as you proceed up from the surface. The air in the atmosphere consists of 78 % nitrogen, 21 % oxygen, and 0.9 % argon. The remaining 0.1 % of the atmosphere consists of ozone, water vapor, carbon dioxide, methane, helium, and neon. The atmosphere is divided into different regions. The lowest two layers are the troposphere (the layer closest to the earth) and the stratosphere respectively. These two layers contain more than 99 % of the atmospheric molecules.

2. Standard atmosphere (atm) is an obsolete pressure and stress unit which should be discontinued. It is unit of pressure equal to the air pressure measured at mean sea level.

1 atm = 101 325 Pa

Technical atmosphere (at) is an obsolete MKpS pressure and sttress derived unit.

1 at = 98 066.5 Pa

1 atm = 1.033 227 453 at

standard mean ocean water    →   standardna prosječna oceanska voda

Standard mean ocean water (SMOW) is a standard sample of pure water of accurately known isotopic composition which is maintained by the International Atomic Energy Agency. It is used for precise calibration of density and isotopic composition measurements.

technical atmosphere    →   tehnička atmosfera

See Atmosphere

standard deviation    →   standardna devijacija

Standard deviation (σ) is a measure of the dispersion of a set of data from its mean. Standard deviation is a statistical term that measures the amount of variability or dispersion around an average

Suppose there are many measurements of a quantity presumed to be similar, like the size of peas in a pod. If the number of readings for each size were plotted, a bell-shaped curve would probably result, with a few small and large peas and most clustered around the average size. Around two-thirds of all measurements fall in the range spanned by the standard deviation, a measure of the spread.

standard hydrogen electrode    →   standardna vodikova elektroda

Standard hydrogen electrode is a system in which hydrogen ion and gaseous hydrogen are present in their standard states. The convention is to designate the cell so that the standard hydrogen electrode is written first.

The electrode is used as a reference (of zero) for the values of other standard electrode potentials.

atmospheric pressure    →   atmosferski tlak

Atmospheric pressure is the pressure exerted by weight of the air above it at any point on the earth’s surface. At sea level the atmosphere will support a column of mercury about 760 mm high. This decreases with increasing altitude. The standard value for the atmospheric pressure at sea level in SI units is 101 325 Pa.

standard electrode potential    →   standardni elektrodni potencijal

Standard electrode potential (E°) (standard reduction potentials) are defined by measuring the potential relative to a standard hydrogen electrode using 1 mol solution at 25 °C. The convention is to designate the cell so that the oxidised form is written first. For example,

The e.m.f. of this cell is -0.76 V and the standard electrode potential of the Zn²+|Zn half cell is -0.76 V.

boiling point    →   vrelište

Boiling point is the temperature at which the vapour pressure of a liquid is equal to the external pressure on the liquid. The standard boiling point is the temperature at which the vapour pressure of a liquid equals standard pressure (101 325 Pa).

practical salinity    →   praktični salinitet

Practical salinity S_P is defined on the Practical Salinity Scale of 1978 (PSS-78) in terms of the conductivity ratio K₁₅ which is the electrical conductivity of the sample at temperature t₆₈ = 15 °C and pressure equal to one standard atmosphere, divided by the conductivity of a standard potassium chloride (KCl) solution at the same temperature and pressure. The mass fraction of KCl in the standard solution is 0.0324356 (32.4356 g of KCl in 1 kg of solution). When K₁₅ = 1, the Practical Salinity P S is by definition 35. The conductivity of that reference solution is C(35,1568,0) = 42.914 mS/cm = 4.2914 S/m (Siemens per meter). Note that Practical Salinity is a unit-less quantity. Though sometimes convenient, it is technically incorrect to quote Practical Salinity in "psu". When K₁₅ is not unity, S_P and K₁₅ are related by the PSS-78 equation

At a temperature of t₆₈ = 15 °C, R_t is simply K₁₅ and Practical Salinity S_P can be determined from the above equation. For temperatures other than t₆₈ = 15 °C, Practical Salinity S_P is given by the following function of R_t (k = 0.0162)