CHEMISTRY GLOSSARY

Ziegler process    →   Zieglerov proces

Ziegler process is an industrial process for the manufacture of high-density polyethene using catalysts of titanium(IV) chloride (TiCl₄) and aluminium alkyls (e.g. triethylaluminium, Al(C₂H₅)₃). The process was introduced in 1953 by the German chemist Karl Ziegler (1898-1973). It allowed the manufacture of polythene at lower temperatures (about 60 °C) and pressures (about 1 atm) than used in the original process.

aerogel    →   aerogel

Aerogel is a low-density porous transparent material that consists of more than 90 % air. Usually based on metal oxides or silica, aerogels are used as drying agents and insulators.

alkali metal    →   alkalijski metal

Alkali metal is a term that refers to six elements: lithium (Li), sodium (Na), potassium (K), rubidium (Rb), caesium (Cs), and francium (Fr). These elements make up group 1 of the periodic table of elements. They all form singly charged positive ions, and are extremely reactive. They react violently with water, forming hydroxides and releasing hydrogen gas and heat. Caesium and francium are the most reactive and lithium is the least.

alkaline earth metal    →   zemnoalkalijski metal

Alkali earth metal is a term that refers to six elements: beryllium (Be), magnesium (Mg), calcium (Ca), strontium (Sr), barium (Ba), and radium (Ra). These elements make up group 2 of the periodic table of elements. They all exhibit a single oxidation state, +2. They are all light and very reactive. Barium and radium are the most reactive and beryllium is the least.

To denote slightly soluble metal oxides chemists formerly used the term "earth". The oxides of barium, strontium, and calcium resemble alumina (Al₂O₃), a typical "earth", but form alkaline mixtures with water. For this reason barium, strontium, and calcium were called alkaline earth metals. This name has now been extended to include all of the elements of group 2.

atmosphere    →   atmosfera

1. Atmosphere is the column of air which is extending several hundred kilometers above the surface the Earth's surface. The density of this air decreases as you proceed up from the surface. The air in the atmosphere consists of 78 % nitrogen, 21 % oxygen, and 0.9 % argon. The remaining 0.1 % of the atmosphere consists of ozone, water vapor, carbon dioxide, methane, helium, and neon. The atmosphere is divided into different regions. The lowest two layers are the troposphere (the layer closest to the earth) and the stratosphere respectively. These two layers contain more than 99 % of the atmospheric molecules.

2. Standard atmosphere (atm) is an obsolete pressure and stress unit which should be discontinued. It is unit of pressure equal to the air pressure measured at mean sea level.

1 atm = 101 325 Pa

Technical atmosphere (at) is an obsolete MKpS pressure and sttress derived unit.

1 at = 98 066.5 Pa

1 atm = 1.033 227 453 at

barytes    →   barit

Barytes is an orthorhombic mineral, form barium sulphate, BaSO₄, the chief of barium. It is usually white but my also be yellow, grey or brown. Large deposits occur in Andalusia, Spain and in the USA.

effusion    →   efuzija

Effusion is the flow of a gas through a small aperture. The relative rates at which gases effuse, under the same conditions, is approximately inversely proportional to the square of their densities.

fluid mechanics    →   mehanika fluida

Fluid mechanics is the study of various properties of the fluid (liquids and gases): velocity, pressure, density and temperature, as functions of space and time.

gauss    →   gaus

Gauss (G) is a non-SI unit of magnetic flux density (B). 1 G = 10^-4 T.

bismuth    →   bizmut

Bismuth was discovered by Claude Geoffroy (France) in 1753. The origin of the name comes from the German words Weisse Masse meaning white mass; now spelled wismut and bisemutum. It is hard, brittle, steel-grey metal with a pink tint. Stable in oxygen and water. Dissolves in concentrated nitric acid. Bismuth can be found free in nature and in minerals like bismuthine (Bi₂S₃) and in bismuth ochre (Bi₂O₃) Main use is in pharmaceuticals and low melting point alloys used as fuses.