CHEMISTRY GLOSSARY

chlorinity    →   klorinitet

Originally chlorinity (symbol Cl) was defined as the weight of chlorine in grams per kilogram of seawater after the bromides and iodides had been replaced by chlorides. To make the definition independent of atomic weights, chlorinity is now defined as 0.3285233 times the weight of silver equivalent to all the halides.

The Mohr-Knudsen titration method served oceanographers for more than 60 years to determine salinity from chlorinity. This modification of the Mohr method uses special volumetric glassware calibrated directly in chlorinity units. The Mohr method uses potassium chromate (K₂CrO₄) as an indicator in the titration of chloride ions chloride (plus a small amount of bromide and iodide) with a silver nitrate (AgNO₃) standard solution.

The other halides present are similarly precipitated.

A problem in the Mohr titration was that silver nitrate is not well suited for a primary standard. The Danish physicist Martin Knudsen (1871-1949) suggested that a standard seawater (Eau de mer Normale or Copenhagen Normal Water) be created and distributed to oceanographic laboratories throughout the world. This water was then used to standardize the silver nitrate solutions. In this way all chlorinity determinations were referred to one and the same standard which gave great internal consistency.

The relationship between chlorinity Cl and salinity S as set forth in Knudsen's tables is

In 1962, however, a better expression for the relationship between total dissolved salts and chlorinity was found to be

Petri dish    →   Petrijeva zdjelica

Petri dish is a shallow glass or plastic flat bottomed dish with a lid. Used primarily in laboratories for the culture of bacteria and other microorganisms on specially prepared media. It was named after the German bacteriologist Julius Richard Petri (1852-1921) who invented it in 1877.

titar    →   titar

Titar (T) is a mass of titrated matter which is equivalent to 1 cm³ of solution. It is shown as T = 2.356 mg HCl / 1.0 cm³ NaOH, 0.1000 moldm^-3, and it is usually shown in a table form. If the concentration of used standard solution (c) differs from one outlined in the table data (c₀), the factor of correction (f) is induced

Titar is usually used in industrial operational laboratories where from titar tables mass or percentage of the ingredient in question is directly read.

water jet vacuum pump    →   vodena sisaljka

The water jet vacuum pump or vacuum aspirator is one of the most popular devices that produces vacuum in laboratories. The rapid flow of water through the device creates a vacuum in a side-arm that is connected to a vacuum application such a Buchner flask. The water jet vacuum pump creates a vacuum by means of Venturi effect named after the Italian physicist Giovanni Battista Venturi (1746–1822). The Venturi effect is the reduction in fluid pressure that results when a fluid flows through a constricted section of pipe. Water jet pumps are manufactured of glass, plastic or metal, depending on the conditions in which they are used.