CHEMISTRY GLOSSARY

Tafel plot    →   Tafelov dijagram

Tafel plot is the graph of the logarithm of the current density j against the overpotential η in electrochemistry in the high overpotential limit. An electrode when polarised frequently yields a current potential relationship over a region which can be approximated by:

where η is change in open circuit potential, i is the current density, B and i₀ is constants. B is known as the Tafel Slope. If this behaviour is observed a plot of the semilogarithmic components is known as the Tafel line and the diagram is called the Tafel diagram.

thermometer    →   termometar

Thermometers are devices for measuring temperature. Linear and volume thermal expansion are macroscopic properties of matter, which can be easily measured, relative to measurements of microscopic properties, on the basis of which, temperature is defined. Thermometers based on thermal expansion are secondary instruments that is, they have to be calibrated in comparison to a standard thermometer. In a thermometer with liquid, mercury or alcohol is placed in a small glass container. If temperature increases, the liquid undergoes volume expansion and rises in a capillary. The level of the raised liquid is the measure of temperature. Mercury thermometers measure temperatures in the temperature range between -39 °C and 300 °C. Alcohol thermometers measure lower temperatures. Bimetal thermometers have a spiral spring, which consists of two metals with different coefficients of linear expansion. When temperature changes, metals undergo different change in length and the consequence twisting of the spring is transferred to a pointer, the deflection of which is the measure of temperature.

titar    →   titar

Titar (T) is a mass of titrated matter which is equivalent to 1 cm³ of solution. It is shown as T = 2.356 mg HCl / 1.0 cm³ NaOH, 0.1000 moldm^-3, and it is usually shown in a table form. If the concentration of used standard solution (c) differs from one outlined in the table data (c₀), the factor of correction (f) is induced

Titar is usually used in industrial operational laboratories where from titar tables mass or percentage of the ingredient in question is directly read.

van’t Hoff equation    →   van Hoffova jednadžba

Van’t Hoff equation is the equation expressing the temperature dependence on the equilibrium constant K of a chemical reaction:

where Δ_rH° is the standard enthalpy of reaction, R the molar gas constant, and T the temperature.

volumetric flask    →   odmjerna tikvica

Volumetric flasks are bottles made of glass, in a pear like in shape with long thin necks and flat bottoms. All come with a ground glass stopper for a tight seal. Volume marking is cut in glass with fluoride acid around the neck, so that parallax should be avoided (flask is put in front of the eyes so that one can see only a straight horizontal line). A volumetric flask is calibrated to contain (TC or In) the indicated volume of water at 20 °C when the bottom of the meniscus is adjusted to just rest on the center of the line marked on the neck of the flask. They are used for preparing the exactly known volume of sample solution and standard solutions of reagents. On each flask with volume designation a temperature on which the flask has been calibrated is designated.

Winkler’s method    →   Winklerova metoda

Winkler’s method was once a common method used to determine the dissolved oxygen concentration by titration. Now rarely used due to the accuracy and low price of oxygen meters.

The water sample is first treated with excess manganese(II) sulfate solution and then with an alkaline solution of potassium iodide. The Mn(OH)₂ initially formed reacts with the dissolved oxygen. The amount of MnO(OH)₂ formed is determined by reaction with iodide ion in acidic solution. The iodine formed may be titrated against standard thiosulfate solution, using starch as an indicator.

Heyrovsky-Ilkovic equation    →   Heyrovsky-Ilkovičeva jednadžba

The Heyrovsky-Ilkovic equation describes the entire current-potential curve (polarographic wave) of a reversible redox system in polarography

where R is the gas constant, T is the absolute temperature, F is the Faraday constant, n denotes the number of electrons taking part in the electrode reaction. E_1/2 is a unique potential (for a given reaction and supporting electrolyte) termed the half-wave potential.

In order to obtain E_1/2 from the above equation, we plot a graph of ln[(i_d-i)/i] against E. The intercept on the x-axis gives then an accurate value of E_1/2. The slope of the obtained straight line is equal to nF/RT from which n is determined.