CHEMISTRY GLOSSARY

Beer’s law    →   Beerov zakon

Beer’s law (or Beer-Lambert law) is the functional relationship between the quantity measured in an absorption method (A) and the quantity sought, the analyte concentration (c). As a consequence of interactions between the photons and absorbing particles, the power of the beam is attenuated from P_o to P. Beer’s law can be written

where A is the absorbance at a given wavelength of light, ε is the molar absorbtivity or extinction coefficient (L mol^-1 cm^-1), unique to each molecule and varying with wavelength, b is the length of light path through the sample (cm), and c is the concentration of the compound in solution (mol L^-1).

equation of state    →   jednadžba stanja

Equation of state is an equation relating the pressure, volume, and temperature of a substance or system. Equation of state for ideal gas

where p is pressure, V molar volume, T temperature, and R the molar gas constant (8.314 JK^-1mol^-1).

gravimetrical factor    →   gravimetrijski faktor

Gravimetrical factor is stechiometric proportion between molar mass of analyte and molar mass of precipitate in gravimetry.

heat of vaporisation    →   toplina isparavanja

Heat of vaporisation or enthalpy of vaporisation is the heat required to convert a substance from the liquid to the gaseous state with no temperature change (also called latent heat of vaporization).

law of chemical equilibrium    →   zakon o kemijskoj ravnoteži

Law of chemical equilibrium (also called the law of mass action) states that the rate at which a substance reacts is proportional to its active mass (i.e. to its molar concentration). Thus, the velocity of a chemical reaction is proportional to the product of the concentration of the reactants.

gravimetry    →   gravimetrija

Gravimetry is the quantitative measurement of an analyte by weighing a pure, solid form of the analyte. Since gravimetric analysis is an absolute measurement, it is the principal method for analysing and preparing primary standards.

A typical experimental procedure to determine an unknown concentration of an analyte in a solution is as follows:

- quantitatively precipitate the analyte from the solution

- collect the precipitate by filtering and wash it to remove impurities

- dry the solid in an oven to remove the solvent

- weigh the solid on an analytical balance

- calculate the analyte concentration in the original solution based on the weight of the precipitate.

heat capacity    →   toplinski kapacitet

Heat capacity is defined in general as dQ/dT, where dQ is the amount of heat that must be added to a system to increase its temperature by a small amount dT. The heat capacity at a constant pressure is C_p = (∂H/∂T)_p; that at a constant volume is C_V = (∂E/∂T)_V, where H is enthalpy, E is internal energy, p is pressure, V is volume, and T is temperature. An upper case C normally indicates the molar heat capacity, while a lower case c is used for the specific (per unit mass) heat capacity.

Henry’s law    →   Henryjev zakon

Henry’s law was discovered in 1801 by the British chemist William Henry (1775-1836). At a constant temperature the mass of gas dissolved in a liquid at equilibrium is proportional to the partial pressure of the gas. It applies only to gases that do not react with the solvent.

where p_i is the partial pressure of component i above the solution, x_i is its mole fraction in the solution, and K_x is the Henry’s law constant (a characteristic of the given gas and solvent, as well as the temperature).

ideal gas law    →   jednadžba stanja idealnog plina

The generalized ideal gas law is derived from a combination of the laws of Boyle and Charles. Ideal gas law is the equation of state

which defines an ideal gas, where p is pressure, V molar volume, T temperature, and R the molar gas constant (8.314 JK^-1mol^-1).

normal conditions    →   normalni uvjeti

Gas is under normal (or standard) conditions when: p₀ = 10⁵ Pa and T₀ = 273.15 K (0 °C). IUPAC recommends that the former use of the pressure of 1 atm as standard pressure (equivalent to 101 325 Pa) should be discontinued. At these conditions, the molar volume of gas V_m0 is 0.022 711 m³ (22.711 L).