CHEMISTRY GLOSSARY

formaldehyde    →   formaldehid

Formaldehyde (methanal) is a colourless gas, HCHO; r.d. 0.815 (at -20 °C); m.p. -92 °C; b.p. -21 °C. It is the simplest aldehyde, made by the catalytic oxidation of methanol (500 °C; silver catalyst) by air. It forms two polymers: methanal trimer and polymethanal.

formula    →   formula

See Chemical compound formula

fouling    →   obrastanje

1. Fouling is the deposition of insoluble materials, such as bacteria, colloids, oxides and water-borne debris, onto the surface of a reverse osmosis or ultrafiltration membrane. Fouling is associated with decreased flux rates and may also reduce the rejection rates of reverse osmosis membranes. Fouling also refers to the accumulation of normally inorganic deposits on heat exchanger tubing.

2. Fouling is an accumulation of marine organism deposits on a submerged metal surface.

cetane number    →   cetanski broj

Cetane number is a measure of the ignition quality of diesel fuel. It denotes the volume fraction of cetane (C₁₆H₃₄) in a combustible mixture (containing cetane and 1-methylnapthalene) whose ignition characteristics match those of the diesel fuel being tested. Cetane is a collection of un-branched open chain alkane molecule that ignites very easily under compression, so it was assigned a cetane number of 100, while alpha-methyl naphthalene was assigned a cetane number of 0.

chain reaction    →   lančana reakcija

Chain reaction is a reaction done in three steps: initiation in which usually radicals are made which react with other molecules in stage of propagation and, when all reactants are spent, it ends by termination when all available radicals are completely spent.

Nuclear chain reaction refers to a process in which neutrons released in fission produce an additional fission in at least one further nucleus. Nuclear power plants operate by precisely controlling the rate at which nuclear reactions occur. On the other hand, nuclear weapons are specifically engineered to produce a reaction that is so fast and intense it cannot be controlled after it has started.

Charles’ law    →   Charlesov zakon

The volume of a fixed mass of gas at a constant pressure expand by the constant fraction of its volume at 0 °C. For each Celsius or kelvin degree its temperature is raised. For any ideal gas fraction it is approximately 1/273. This can be expressed by the equation

were V° is the volume at 0°C and V is its volume at t°C.

This is equivalent to the statement that the volume of a fixed mass of gas at a constant pressure is proportional to its thermodynamic temperature

This law also know as Gay-Lussac’s law.

An equation similar to the one given above applies to pressures for ideal gases:

fractional crystallisation    →   frakcijska kristalizacija

Fractional crystallisation is a method of separating a mixture of soluble solids by dissolving them in a suitable hot solvent and then lowering the temperature slowly. The least soluble component will crystallise out first, leaving the other components in the solution. By controlling the temperature, it is sometimes possible to remove each component in turn.

freezing    →   smrzavanje

Freezing is the change of a liquid into a solid state as the temperature decreases. For water, the freezing point is 0 °C (or 273.16 K).

freezing point    →   ledište

Freezing point is the temperature at which a liquid becomes a solid at normal atmospheric pressure.

See Melting point

frequency    →   frekvencija

Frequency (ν) is the number of cycles of a periodic phenomenon divided by time. Hertz (Hz) is the SI derived unit, with a special name, for frequency, equal to s^-1. It was named after the German scientist Heinrich Hertza (1857-1894).