CHEMISTRY GLOSSARY

masking reagent    →   maskirajući reagens

Masking reagent reacts with sample components which can increase the analysis results.

microchemistry    →   mikrokemija

Microchemistry is a branch of chemistry that concerns isolating, identifying and an analysis of very small quantities of sample (few mg). It uses delicate reactions, special equipment and microscopes.

PCl5 reaction    →   reakcija s PCl5

Reaction with phosphorus pentachloride (PCl₅) is a characteristic of organic compounds containing a hydroxyl group and this reaction is used to identify these compounds in an organic analysis.

polarimetry    →   polarimetrija

Polarimetry measures the overall turning of the flat of polarised light. It is used when analysing optically active substances and compounds.

sample    →   uzorak

In chemical analysis total amount of matter is not analysed, but only a smaller part of it. This small part is called analysis sample and it must represent the whole amount of the matter that is being analysed.

spectroscopy    →   spektroskopija

Spectroscopy is the analysis of the lines of light emitted from excited atoms as the electrons drop back through their orbitals. These lines give the energy and distances of the electronic orbitals.

titrant    →   titrant

Titrant is the substance that quantitatively reacts with the analyte in a titration. The titrant is usually a standard solution added carefully to the analyte until the reaction is complete. The amount of analyte is calculated from the volume and concentration of titrant required for the complete reaction.

X-ray crystallography    →   rendgenska kristalografija

X-ray crystallography is a determination of a three dimensional arrangements of atoms in a crystal by analysis of X-ray diffraction patterns.

Knudsen burette    →   Knudsenova bireta

Knudsen's automatic bulb-burette, developed by the Danish physicist Martin Knudsen (1871-1949), is designed in a way that even routine field analysis in a boat laboratory would provide highly accurate measurements. The burette is filled with a mixture of silver nitrate from reservoir R, located above the burette, by opening the A valve. When the solution crosses the three-way C valve the A valve is closed preventing further solution flow in to the burette. Any extra solution is caught in the W bowl. Turn the C valve, which marks the zero on the scale, in order to allow atmospheric air to enter the burette. Since most open-ocean samples lie in a relatively small chlorinity range, the burette is designed so that much of its capacity is in the bulb (B). This allows the titration to be quick (by quickly releasing contents from the B area) and reduces the error that occurs from the slow drainage along the inner wall of the burette.

Each millimeter is divided in to twenty parts (double millimeter division of the Knudsen burette) which allows for highly accurate measurements (the scale is read up to a precision of 0.005 mL). From 0 to 16 the burette isn't divided, that usually starts from 16 and goes until 20.5 or 21.5. A single double millimeter on a Knudsen burette scale corresponds to one permille of chloride in the seawater sample. This burette can be used for titration of water from all of the oceans and seas, with the exemptions being areas with very low salinity (e.g. the Baltic Sea) and river estuaries which require the use of normal burettes.

polarogram    →   polarogram

Polarogram is a graph of current versus potential in a polarographic analysis. The position of a polarographic wave in a polarogram along the x axis (E_1/2) provides an identity of the substance while the magnitude of the limiting diffusion current (i_d) provides the concentration of this substance.