CHEMISTRY GLOSSARY

lead-acid battery    →   olovni akumulator

Lead-acid battery is a electrical storage device that uses a reversible chemical reaction to store energy. It was invented in 1859 by French physicist Gaston Planté. Lead-acid batteries are composed of a lead(IV) oxide cathode, a sponge metallic lead anode and a sulphuric acid solution electrolyte.

In charging, the electrical energy supplied to the battery is changed to chemical energy and stored. The chemical reaction during recharge is normally written:

In discharging, the chemical energy stored in the battery is changed to electrical energy. During discharge, lead sulfate (PbSO4) is formed on both the positive and negative plates. The chemical reaction during discharge is normally written:

Lead acid batteries are low cost, robust, tolerant to abuse, tried and tested. For higher power applications with intermittent loads however, they are generally too big and heavy and they suffer from a shorter cycle life.

luminescence    →   luminiscencija

Luminescence (from Latin lumen, light) is the emission of electromagnetic radiation (UV, visible or IR) from atoms or molecules as a result of the transition of an electronically excited state to a lower energy state, usually the ground state. Luminescence can be divided into categories by duration (fluorescence or phosphorescence) or by the mechanism that creates the light (radioluminescence, electroluminescence, photoluminescence, thermoluminescence, triboluminescence, chemiluminescence, bioluminescence). The prefix identifies the energy source responsible for generating or releasing the light.

Phosphorescence is emission of light from a substance exposed to radiation and persisting as an afterglow after the source of excitation has been removed. Fluorescence, on the other hand, is an almost instantaneous effect, ending within about 10^-8 second after excitation.

Lyman series    →   Lymanova serija

Lyman series is the series of lines in the spectrum of the hydrogen atom which corresponds to transitions between the ground state (principal quantum number n = 1) and successive excited states.

melting point    →   talište

Melting point is the temperature at which a solid becomes a liquid at normal atmospheric pressure.

A more specific definition of melting point (or freezing point) is the temperature at which the solid and liquid phases of a substance are in equilibrium at a specified pressure (normally taken to be atmospheric unless stated otherwise). A pure substance under standard condition of pressure has a single reproducible melting point. The terms melting point and freezing point are often used interchangeably, depending on whether the substance is being heated or cooled.

metal    →   metal

Metals are materials in which the highest occupied energy band (conduction band) is only partially filled with electrons.

Their physical properties generally include:

- They are good conductors of heat and electricity. The electrical conductivity of metals generally decreases with temperature.

- They are malleable and ductile in their solid state.

- They show metallic lustre.

- They are opaque.

- They have high density.

- They are solids (except mercury)

- They have a crystal structure in which each atom is surrounded by eight to twelve near neighbours

Their chemical properties generally are:

- They have one to four valence electrons.

- They have low ionisation potentials; they readily lose electrons.

- They are good reducing agents.

- They have hydroxides which are bases or amphoteric.

- They are electropositive.

Metallic characteristics of the elements decrease and non-metallic characteristics increase with the increase of valence electrons. Also metallic characteristics increase with the number of electron shells. Therefore, there is no sharp dividing line between the metals and non-metals.

Of the 114 elements now known, only 17 show primarily non-metallic characteristics, 7 others are metalloids, and 89 may be classed as metals.

molality    →   molalitet

Molality or molal concentration (b; formerly m) is a concentration in which the amount of solute is stated in moles and the amount of solvent in kilograms.

The unit of molality is mol kg^-1.

mole    →   mol

Mole (mol) is the SI base unit of amount of substance.

The mole is the amount of substance of a system which contains as many elementary entities as there are atoms in 0.012 kg of carbon 12.

When the mole is used, the elementary entities must be specified and may be atoms, molecules, ions, electrons, other particles, or specified groups of such particles. In this definition, it is understood that the carbon 12 atoms are unbound, at rest and in their ground state.

mutarotation    →   mutarotacija

Mutarotation is the change in optical rotation accompanying epimerization. In carbohydrate chemistry this term usually refers to epimerization at the hemiacetal carbon atom. In general α- and β-form are stable solids, but in solution they rapidly equilibrate. For example, D-glucose exists in an equilibrium mixture of 36 % α-D-glucopyranose and 64 % β-D-glucopyranose, with only a tiny fraction in the open-chain form. The equilibration occurs via the ring opening of the cyclic sugar at the anomeric center with the acyclic form as the intermediate. Mutarotation was discovered by French chemist Augustin-Pierre Dubrunfaut (1797-1881) in 1846.

Nernst’s division law    →   Nernstov zakon razdjeljenja

Nernst’s division law states that a substance is divided between two solvents in a way that proportion of concentrations of that substance is at certain temperatures constant, under the condition that both solvents are in the same molecular state. Division coefficient is a proportion of substance concentration in solvents A i B at a defined temperature.

Appearance of division is used for substance extraction.

non-metal    →   nemetal

Non-metals are defined as elements that are not metals.

Their physical properties generally include:

• They are poor conductors.
• They are brittle, not ductile in their solid state.
• They show no metallic lustre.
• They may be transparent or translucent.
• They have low density.
• They form molecules which consists of atoms covalently bonded; the noble gases are monoatomic.

Their chemical properties are generally:

• They usually have four to eight valence electrons.
• They have high electron affinities (except the noble gases)
• They are good oxidising agents (except the noble gases)
• They have hydroxides which are acidic (except the noble gases)
• They are electronegative.