CHEMISTRY GLOSSARY

second-order reactions    →   reakcije drugog reda

Second-order reaction is a reaction with a rate law that is proportional to either the concentration of a reactant squared, or the product of concentrations of two reactants.

For a general unimolecular reaction,

The reaction rate expression for a second order reaction is

If assumed that the concentration of reactant A is [A]_o at t=0 and [A] at time T, the variables in the rate equation and integrate can be separated. The integrated rate law for a second-order reaction can be easily shown to be

thermal resistance    →   toplinski otpor

Heat always flows from a higher to a lower temperature level. The driving force for the heat flux lies in the temperature difference ΔT between two temperature levels. Analogous to Ohm’s law, the following holds:

where H = dQ/dt is heat flux, measured in watts, ΔT is temperature difference across the thermal resistance, measured in kelvin, and R_th is thermal resistance, measured in K/W.

For example, suppose there were two houses with walls of equal thickness; one is made of glass and the other of asbestos. On a cold day, heat would pass through the glass house much faster. The thermal restistance of asbestos is then higher than of glass.

If the thermal Ohm’s law is divided by the heat capacity C, Newton’s law of cooling is obtained:

where dT/dt is rate of cooling or heating, measured in K s^-1, and C is heat capacity, measured in J K^-1.

wavenumber    →   valni broj

Wavenumber is the number of wave cycles per unit distance.

There are unfortunately two different definitions of the wavenumber.

Wavenumber, k, is most frequently defined as

with wavelength λ, phase velocity of wave v_p, and angular frequency ω.

Less frequently it is defined simply as

One must be careful to note which definition is in use. Wavenumbers are used extensively in infrared spectroscopy, and usually have units of cm^-1.

X-ray tube    →   rendgenska cijev

X-ray tube is a cathode ray tube that focuses energetic streams of electrons on a metal target, causing the metal to emit X-rays. The basic principle of the X-ray tube has not changed significantly since Roentgen's 1895 discovery. Current applied to a metal cathode (about 50 000 V) produces free electrons. The X-rays are produced when the rapidly moving electrons are suddenly stopped as they strike the metal target of the tube.